Tilt Sensor - Victory Motorcycles Vegas 2010 Manuel D'utilisation

Engine Break-in Period
Starting the Engine
CAUTION! Do not rev the engine or put the transmission in gear immediately after starting the engine. Allow the engine to idle for
about one minute after a cold start, or 30 seconds after a warm start, to allow the oil to reach all areas requiring lubrication before
the engine is put under load.
7. Leaving the throttle closed, press and hold the starter button to start the engine. Release the button promptly when
the engine starts. If the engine does not start within 10 seconds, release the starter button. Wait five seconds, then
try again.
Tip: Hold the starter button for as short a time as possible to minimize battery drain. Do not hold the starter button for more than 10
seconds at one time.
8. If either the check engine indicator or the low oil pressure indicator does not go out after the engine starts, stop
the engine. Refer to either the check engine indicator information on page 36 or the low oil pressure indicator
information on page 37.

Tilt Sensor

The tilt sensor (if equipped) stops the engine if the motorcycle tips beyond 45 degrees to one side. If this occurs, the
check engine light will also illuminate.To restart the engine, cycle the ignition switch to the OFF position, wait 10
seconds, then restart the engine.
Operation
63