RECARO Ergomed Instructions D'utilisation page 26

How to operate your RECARO seat
6 Adjusting the side bolsters on the
sitting area (ES model only)
Figure A
You adjust the side bolsters of the sitting
area with the rocker switch on the operating
panel.
To set the side bolsters closer, press the
rocker switch upward. To set the side
bolsters further apart, press the rocker
switch downward.
7 Adjusting the seat height
Figure A
You can adjust the height of your RECARO
seat to your individual setting using the
switch.
Risk of pinching
Adjusting the
changes the amount of space required.
Ensure that no-one reaches under the
seat with their hands or places their
feet under the seat.
Push the switch to the rear and up to raise
the seat.
Push the switch to the rear and down to
lower the seat.
8 Adjusting the distance of the seat
from the pedals
Figure A
There are two possibilities here, depending
on the vehicle type in question. Your
RECARO seat has been fitted with either a
RECARO adapter and the standard seat
rails or with a RECARO base frame and
RECARO seat rails.
26
height of the
Risk of pinching
Adjusting the length of the seat
changes the amount of space requir-
ed. Ensure that no-one reaches into
the area where adjustment is taking
place or puts their feet under the seat
or near the seat rails.
Manual
RECARO adapter and standard seat
rails (not shown)
In this case, you can move your RECARO
seat forward and back in exactly the same
way as with a standard seat. If in doubt,
please refer to the operating instructions for
your vehicle.
RECARO console and RECARO
seat rails – Figure A
seat
In this case, adjust your RECARO seat
using the adjustment bar.
To release the seat locking mechanism, lift
the adjustment bar so that the seat can be
pushed forward or back. Release the
adjustment bar once you have reached the
desired position. Make sure that the seat
audibly engages on both sides and that the
adjustment bar returns to its original
position.
Electrical
If electrical length adjustment is available in
the vehicle as standard or is offered as an
option from RECARO, it can be operated
with the switch.
To decrease the distance to the pedals,
press the switch forward in the direction of
travel. To increase the distance, press the
switch opposite the direction of travel.