Demo Mode - Dentsply Sirona Propex Pixi Manuel De L'utilisateur

Step-by-Step Instructions
6.8

Demo Mode

The built-in demo mode is available to become acquainted with the
device and to demonstrate its operation.
1. Disconnect the measuring cable or the charger from the device, if
connected, and turn the device off.
2. To start the demo mode, press and hold the
for about 2 seconds. until the whole display turns on
immediately turns off again accompanied by two beeps.
3. During the demo cycle the device operating sequence is shown on
the screen.
4. Demo cycles are repeated automatically until interrupted by the
operator.
5. To exit the demo mode press the
about 1 second until a beep sounds. The device shuts down.
Note
If the measurement cable is connected to Propex Pixi
demo cycle, the device switches automatically to normal operation
mode.
END-IFU-PROPEX-PIXI-V15- WEB-EUR-Multilingual -2020-11
Fig. 13
"ON / OFF" button and hold for
"ON / OFF" button
(Fig. 13) and
®
during the
21/222