Filling With Fuel; Start-Up; Cold Start - Vallfirest VFT Black Hawk BH1-4H Importantes Informations Pour L'utilisateur

4.3.

FILLING WITH FUEL

1. The fuel tank is a part of the motor pump in the standard
model.
2. Fuel: Use 86 octane gasoline or a higher octane gasoline.
No oil is required in the fuel. Read the motor user manual for
more details.
IMPORTANT
There must not be any fire in the motor pump area and
nobody must be SMOKING given that it uses gasoline
(naphtha).
4.4. START-UP (STARTING)

4.4.1. Cold Start

See instructions on FILLING WITH FUEL above:
1. Connect the suction oversleeve.
2. Fill the pump (section 4.2. of this Manual).
3. Connect the discharge or pressure hose to the pump.
4. Place the gasoline switch in the "open" position. Close
when the motor turns off.
5. Place the starter switch in the "open" position. Close once
the motor has started.
6. Place the gas cam at 1/4 the line.
24
3. When filling the fuel tank, make sure the motor is off.
4. If a spill occurs, clean the entire unit, particularly the area
of the spill and start the motor (dry and clean) far from the
spill area.
5. Use a funnel with a sieve when filling to keep dirt out of the
tank.
7. Place the electrical switch in the
"ON" position.
8. Pull the starter tensor until there is resistance and then pull
strongly.
9. Let the motor heat up a few minutes before increasing the
speed.
1/4