Operating Instructions; Initial Checks; Important; Water Filling And Suction - Vallfirest VFT Black Hawk BH1-4H Importantes Informations Pour L'utilisateur

4. OPERATING INSTRUCTIONS

4.1.

INITIAL CHECKS

Before using the motor pump, follow this check procedure:
1. When you receive and unbox your BH1-4H motor pump,
visually inspect the product and make sure there is no
damage. Contact your Vallfirest representative or customer
service if you see any imperfections:
customer.service@vallfirest.com | Tel. (+34) 93 867 87 79.
2. Before the first use, prepare the motor as it comes dry.
Before each subsequent use, check the levels and refill as
necessary.
- Motor/mechanism fuel level.
- Motor/mechanism oil level.
CAUTION:
Check the oil level before starting the motor. Check the operator's manual for the motor to verify the type of oil needed and
the filling instructions.
4.2.

WATER FILLING AND SUCTION

CAUTION: DO NOT OPERATE THE PUMP WITHOUT
WATER, FILL THE PUMP BEFORE STARTING THE MOTOR.
1. Insert the foot valve with the filter into the suction
oversleeve.
2. Fill the suction oversleeve with water.
3. Connect the suction oversleeve to the pump and check
that it is well-adjusted.
4. Connect the filling pump to the pump outlet and pump
until water comes out of the hole on the white tube.
If you have the model with the filling pump included, open
the stopcock and pump until water comes out of the hole.

IMPORTANT

Check the manufacturer's manual for the motor for
specific instructions on the motor.
3. Check that all suction and release hoses are structurally
firm and show no leakage.
4. Inspect all safety characteristics and make sure they are in
good conditions before using the pump.
5. Each time you plan on using the pump, check that it
was not damaged during prior use. Notify your superior if
the equipment requires repairs. Remember that damaged
equipment may expose you to safety risks.
5. Disconnect the filling pump.
If you have the model with the filling pump included, close
the stopcock.
6. Check that the foot valve does not touch the bottom of
the tank and is not too close to the surface. This will prevent
obstruction in the valve and air suction.
7. Connect the discharge hose.
EN
23