Preventing Damage To The Equipment - Vallfirest VFT Black Hawk BH1-4H Importantes Informations Pour L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
2.3.

PREVENTING DAMAGE TO THE EQUIPMENT

The following recommendations will help prevent damage to
your equipment:
1. Rinse the pump with clean water if the pump has been
used to pump salt or dirty water or water with a high mineral
content or which contains residue or foam-injected water.
Check to make sure all residue is removed for using the pump
again.
2. Always vacuum water with a suction hose filter.
3. Drain all the water from the pump, collectors and lines in
freezing weather. You can also pour a little anti-freeze into
the pump and have it circulate through the pump and pipe
system.
4. Let the motor heat up before using the unit at maximum
performance.
5. Always use lead-free gas or gas at the octane
recommended by the manufacturer.
6. Always check to make sure there is enough oil in the
crankcase before using the motor (check the motor manual
for more details on how to check the oil level as well as on
what type of oil to use).
7. Pump must not be operated without water or without
releasing the water. Operate the pump so it does not
overheat and cause damage to the seals or inside of the
pump.
8. Make sure to correctly fill the pump before starting it and
avoid closing the water release when the pump is on.
9. Use replacement parts supplied by Vallfirest to avoid
damage and/or lose the warranty covering this product.
10. The equipment features anti-vibration elements that
absorb vibration (less than 2.5 nm) so the operator is not
affected. If they need to be replaced, use the original
replacement parts offered by the manufacturer.
EN
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

B21050h14h

Table des Matières