Troubleshooting - GGP ITALY MP 84C Manuel D'utilisation

8. TROUBLESHOOTING

PROBLEM
1. With the key on «ON»,
the light stays off
2. With the key on «START»
the light flashes and the
starter motor does not run
3. With the key is turned to
«START» the light or the
control panel come on,
but the starter motor is not
activated
4. With the key on «START»,
the starter motor runs but
the engine does not start
5. Starting is difficult
or the engine runs
erratically
6. Poor engine performance
during cutting
EN 26
LIKELY CAUSE
The safety device of the electronic
circuit board
has cut in due to:
– badly connected battery
– battery terminals crossed
– completely flat battery
– fuse blown
– electronic circuit board wet
– conditions are not met to allow
starting
– insufficiently charged battery
– malfunction on the starter relay
– insufficiently charged battery
– faulty fuel supply
– faulty ignition
– fault in carburation
– forward speed too high compared
to cutting height
SOLUTION
Turn the key to «STOP» and look
for the cause
of the problem:
– check connections (
– check connections (
– recharge the battery (
– replace the fuse (10 A) (
– dry using tepid air
– check that the conditions allowing
starting are met (
– recharge the battery (
– contact Your Dealer
– recharge the battery (
– check the level in the tank
( 5.3.3)
– open the fuel stopcock
(if present) ( 5.4.1)
– check the fuel filter
– check that spark plug cap is
securely fitted
– check that the electrodes are
clean and have the correct gap
– clean or replace the air filter
– empty the fuel tank and refill with
fresh fuel
– check and replace the fuel filter if
necessary
– reduce the forward speed and/or
raise the cutting deck (
3.4)
3.4)
6.2.3)
6.3.5)
5.2.a)
6.2.3)
6.2.3)
5.4.5)