Cutting Height Adjustment Lever - GGP ITALY MP 84C Manuel D'utilisation

4.5 BLADE ENGAGEMENT
AND BRAKE CONTROL
The mushroom switch allows you to engage the
blades using the electromagnetic clutch:
«A» Pressed = Blades disengaged
«B» Pulled = Blades engaged
– If you engage the
blades without tak-
ing the necessary
safety precautions,
the engine shuts
down and cannot be
restarted ( 5.2)
– Blade disengage-
ment (Pos. «A»),
simultaneously acti-
vates a brake which
stops their rotation in a few seconds.

4.6 CUTTING HEIGHT ADJUSTMENT LEVER

There are seven po-
sitions for this lever
(shown as «1» to «7»
on the label), which
correspond to various
heights between 3
and 8 cm.
– To go from one
position to another,
move the lever side-
ways and put it back
in one of the stop
notches.
4.7 LIGHT AND SOUND WARNING DEVICE
– The sound warning
indicates that the
grass-catcher is full
(
5.4.6).
This light comes on
when the key (4.3) is
in the "ON" position
and stays on while the
machine is running.
– When it flashes, this
means the engine is
not ready to be started
( 5.2).
EN 12
4.5
4.6
4.7
4.8 LEVER FOR TIPPING
THE GRASS-CATCHER (if present)
This pull-out lever tips and empties the grass-
catcher. This means less work for the operator.
Mechanical transmission
4.21 CLUTCH / BRAKE PEDAL
This pedal has two
functions: during
the first part of its
travel it acts as a
clutch, engaging
and disengaging
drive to the wheels,
and in the second
part it acts as a
brake on the rear
wheels.
IMPORTANT
pedal halfway between clutch engagement
or disengagement, as this can cause over-
heating and damage the transmission belt.
NOTE
is moving, keep your foot off the pedal.
4.22 SPEED CHANGE LEVER
This lever has
seven positions
for the 5 forward
speeds, the neutral
position «N», and
reverse «R».
To go from one
speed to another,
press the pedal
(4.21) halfway and
shift the lever as
shown on the label.
WARNING!
verse when the machine has stopped
moving.
4.21
Do not keep the
When the machine
4.22
Only shift into re­