3.5 MOUNTING THE FRONT BUMPER
(if provided)
• Type "I" Bumpers
Mount the front bumper (1) on the bottom of the
frame (2) using the four screws (3).
3
2
1
• Type "II" Bumpers
Fit the two brackets, (1) and (2), on the bottom of
the frame (3) tightening down the screws (4).
Attach the front bumper (5) to the brackets, (1)
and (2), with the screws (6) and the nuts (7).
4
7
2
7
6
5
6
3.6 ASSEMBLY AND COMPLETING
THE REAR PLATE
Assemble the two lower brackets (1) and (2),
following the assembly direction as shown in the
3
4
1
3
3
1
4
4
3
2
illustration, and fasten them with the screws (3)
and nuts (4), tightening them completely.
Remove the two screws (8), which will be
used later.
8
Assemble the lower part (5) of the rear plate and
fasten it to the lower brackets with the screws (6)
and bolts (7), without tightening them completely.
Finish fastening the lower part (5) of the rear
plate, completely tightening the two central
screws (8) that you previously removed and the
four upper screws (9); then tighten the two lower
nuts (7) completely.
9
5
9
8
7
7
5
6
9
8
5
EN
6
9
8
9