Battery Installation; Remote Control - Teac SL-D920 Mode D'emploi

The included remote control allows the main unit to be
operated from a distance.
When operating the remote control, point it towards the
remote sensor on the front panel of the unit.
< Even if the remote control is operated within the
effective range (5 m), remote control operation might
be impossible if there are any obstacles between the
unit and the remote control.
< If the remote control is operated near other products
that generate infrared rays, or if other remote control
devices that use infrared rays are used near the unit,
it might operate incorrectly. Likewise, other products
might also operate incorrectly.

Battery installation

1. Remove the battery compartment cover.
2. Insert two AAA (R03 or UM-4) dry batteries. Make sure
that the batteries are inserted with their positive "+"
and negative "_" polarities oriented correctly.
3. Close the cover.
Battery replacement
If the maximum distance from which the remote control
can operate the main unit decreases, the batteries are
probably exhausted. In this case, replace the batteries with
new ones.

Remote Control

Precautions concerning batteries
< Be sure to insert the batteries with the positive "+" and
negative "_" polarities oriented correctly.
< Use batteries of the same type. Never use different
types of batteries together.
< Rechargeable and non-rechargeable batteries can be
used. Refer to the precautions on their labels.
< When the remote control will not be used for a long
time (more than a month), remove the batteries from
the remote control to prevent them from leaking. If
they do leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
< Do not heat or disassemble batteries and never dispose
of old batteries by throwing them in a fire.
13