Charging The Battery - Wayscral EVERYWAY E-CARRIER Notice D'utilisation

Insertion
mark
Be careful not to exceed the minimum insertion mark. This insertion
mark should never be visible when the bicycle is in use. Tighten the
immersion screw making sure that the stem is in the correct position.
To adjust the position of the handlebar on the stem, loosen the screws
on the stem cover (8), turn the handlebar as much as you want and
tighten these same screws. Take care that the handlebar is correctly
centred.

2. Charging the battery

Before handling the battery, the "Battery" and "Charger" sections
of this user guide must be read to avoid any damage. The bicycle
battery must be charged before the power assistance can be used. To
do this, plug the charger pack plug into a 220 V electrical outlet and
connect the charging cable to the battery socket (19), located at the
rear of the bike, under the luggage rack, beneath a protective cover.
On the top of the battery (19), the charge indicator shows you the
battery charge level. Press the indicator button to activate it. Close the
cover on the charging socket when the operation is complete.
6 mm screw
56
Stem cover
screw
EN