Wayscral EVERYWAY E-CARRIER Notice D'utilisation page 61

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Roller brake adjustment, Shimano Roller brake:
V-Brake adjustment
The pads exert pressure directly on the rim of the wheel. The intensity
of the pressure is controlled by a lever connected to the brake by a
cable. Do not operate the brake lever when the wheel is detached from
the frame.
Position the caliper arms vertically and parallel using the correct
cable tension. Once the cable position has been defined,
tighten the cable with the appropriate screw.
After checking that the wheel does not
turn easily when the brake cable is
pulled, press the brake lever about 10
times as far as possible towards the
handle in order to break in the brake
cable. (a) Press about 10 times
Turn the cable adjustment bolt (A) of
the brake unit or the brake lever so that
there is a play of 15 mm (b) (11 mm for
the BL-C6010) in the brake lever. (The
brake lever play is the distance from
the position where the brake lever is
not actuated to the position where a
force is suddenly felt when the brake
lever is pulled.)
After pressing on the brake lever to
check the braking performance, fix the
cable adjustment bolt with the cable
adjustment nut (B).
61
EN

Publicité

Table des Matières
loading

Table des Matières