Wayscral EVERYWAY E-CARRIER Notice D'utilisation page 85

type of road and constant
braking).
After connecting the charger,
the charging LEDs do not
light up.
After charging for more than
4/5 hours, the
indication LED is still red
(note: it is very important to
charge the battery according
to the instructions to avoid
damaging the equipment).
LCD display:
The speed is not displayed
on the LCD screen.
Troubleshooting charger issues:
3) frequent
headwinds, as well as roads
in poor condition, can reduce
battery performance,
4) the tyre pressure is not
high enough (inflate them),
5) frequent
restarts,
6) the battery has been
stored without being charged
for a long time.
1) problem with the electrical
outlet,
2) faulty contact between the
charger input socket and the
electrical outlet,
3) the temperature is too low.
1) the ambient temperature is
charge 40°C or higher,
2) the ambient temperature is
0°C or lower,
3) the bicycle
charged after use, which
exacerbated the decrease in
charge,
4) the output voltage is too
low to charge the battery.
The magnetic ball installed
on the spoke of the wheel is
too far from the sensor (fixed
to the rear of the frame or to
the front
prevents the sensor from
receiving the signal when the
wheel turns.
hills or 2)
temperatures
your battery must be kept
indoors,
3) this is a normal cause and
the problem will be solved
stops and with improved conditions,
4) inflate the tyres to a
pressure of 3.1 bar,
5) the problem will be solved
with the improvement of the
usage conditions,
6)
battery in accordance with
the instruction manual. If the
problem
your retailer or a qualified
professional.
1) check and repair the
electrical outlet,
2) check and fully insert the
plug,
3) charge indoors.
If the above solutions do not
work, contact your retailer or
a qualified professional.
1) charge the battery below
40°C and in accordance with
the instructions,
2) charge the battery indoors
was not and in accordance with the
instructions,
3) correctly maintain the
battery to avoid exacerbating
the decrease in charge,
4) do not charge with a
voltage lower than 100 V.
If the above solutions do not
work, contact your retailer or
a qualified professional.
Check the distance between
the magnetic ball and the
sensor and make sure it does
not exceed 5 mm.
fork), which
85
in winter or at
below 0°C,
regularly charge the
persists, contact
EN