Inserting Accessories - Thermador Masterpiece Série Mode D'emploi

Inserting Accessories

The oven cavity has 5 rack positions. The rack positions
are counted from the bottom up.
Racks 1 to 3 are fitted with telescopic rack guides.
Note: Always place the Universal Pan on Rack 1 when
using Full Steam. This will prevent food drippings from
burning on to the bottom of the oven.
WARNING
9
RISK OF BURNS
The telescopic rack guides become hot when the
appliance is in use. You must take great care to
avoid burning yourself when they are pulled out.
CAUTION
9
Do not insert any accessories between the
accessory racks as the accessory may tilt over.
NOTICE: Always insert the accessories fully into the
oven cavity so that they do not touch the appliance door
or the glass panel might be damaged.
Racks 4 and 5:
Always insert the accessory between the two guide
▯
rods for a rack position.
The accessories can be pulled out approximately
▯
halfway without tipping.
Note: Ensure that you always insert the accessories into
the oven cavity facing the correct way. See the diagrams
in the following sections for further information.
Telescopic Rack Guides:
You can use the telescopic rack guides to pull the
▯
accessories out further.
Ensure that the accessory is placed evenly onto the
▯
telescopic rack guides. The accessory must rest on
both telescopic rack guides and within the notches at
the front and rear end of the telescopic rack guides.
Example in the picture: Universal pan
Example in the picture: Rack
To remove the accessory, pull it out until the
▯
telescopic rack guides stop. Hold the accessory on
both sides and lift it up.
Stop Function
The accessories can be pulled out approximately halfway
until they lock in place. The stop function prevents the
accessories from tilting when they are pulled out. The
accessories must be inserted into the oven cavity
correctly for the tilt protection to work properly.
When inserting the wire rack, ensure that the stop catch
‚ is at the rear and is facing downwards. The open side
must be facing towards the appliance door and the
curvature must be facing downwards .
¾
23