Bosch TPA 200 Notice Originale page 25

5.4 Check
The tire pressure sensor data of the tires can be
read out from the main menu via "Check". The
reading out of the tire pressure sensor is always
carried out in the same sequence. One begins
from the left-front, then right-front, left-rear and
at the end the tire pressure sensor of the spare
wheel can still be read out.
1. Switch on the TPA 200.
 Main Menu
is displayed.
 Check
is displayed.
2. Confirm with .
 Vehicle
>New Vehicle
(not in the case of operation sequence
"None").
i
If tests on vehicles have already been
performed and saved, and if the opera-
tion sequence is selected for "Job code",
"Registration" or "Model Year", these vehicles
can be selected again and tested.
3. Confirm with .
 Select Make
4. Select " Select Make" with
confirm with .
 Select Model
5. Select " Select Model" with
confirm with .
 Select Year
6. Select " Select Year" with
confirm with .
i
During the work flow "Registration", the regis-
tration number of the vehicle to be tested can
still be entered, before the tire pressure sensor
test with or and then confirm with
 Front Left >Read Sensor
played.
The following menu items can be selected:
Menu item Description
>Read Sensor Tire pressure sensor is read out.
>Req. Repair Select only if the tire pressure sensor
is visibly faulty. A message about re-
pair is made in the test protocol. The
tire pressure sensor is not read out.
>Skip Wheel The selected tire pressure sensor is
not read out.
>Cancel Audit Return to the main menu. No data is
saved.
Robert Bosch GmbH
is displayed
is displayed.
or and
is displayed.
or and
is displayed.
or and
.
is dis-
Operation | TPA 200 | 25
7. Hold the TPA 200 close to the tire valve.

Front Left >Read Sensor
played.
8. Confirm with .
i
In some models, is indicated before
reading out the tire pressure sensor
Drop Pressure
flation pressure must be reduced to 0.5 bar.
The number of signals of the tire pressure
sensor increases due to the pressure change.
Due to the increasing number of signals, the
tire pressure sensor detects TPA 200 faster.
 Tire pressure sensor is read out and sub-
sequently displays the data of the tire
pressure sensor, e.g.
2.5bar Bat:OK
ID:00001A635
i
In case the tire pressure sensor could not be
read out, repeat the search.
9. Confirm with .
10. Read out the tire pressure sensors of all the
wheels according to the indicated sequence.
11. Confirm with .
 Vehicle Data >Save
The following menu items can be selected:
Menu item Description
The measurement data is saved.
Vehicle Data
>Save
Vehicle Data The individual tire pressor sensors
>Edit can be marked with
whether they should be repaired. The
message about repair is then made in
the test protocol. Order numbers or
license numbers can also be edited.
Vehicle Data The measurement data is not saved.
>Exit
 Vehicle Data >Save
 Confirm with
"
Measured data of the tire pressure sensors
are saved.
" Main Menu
is displayed.
1 689 989 200
en
is dis-
. In this case, the tire in-
is displayed.
, showing
is displayed.
.
|
2019-12-24