Cleaning And Maintenance; Storage; Electrical Connection; Disposal And Recycling - Scheppach PES31 Traduction Des Instructions D'origine

9. Cleaning and Maintenance

WARNING! Always remove the plug from the
mains power socket before carrying out any
work on the appliance.
The multi-sander is maintenance-free.
• Always clean the appliance directly after com-
pletion of work.
• Use a dry cloth to clean the housing.
• Remove any sanding dust stuck to the appli-
ance with a brush.
• Never use sharp objects, petrol, solvents or
cleaning agents which can damage plastic. Do
not allow any liquids to get into the interior of the
appliance.
• Always keep the ventilation openings free of
obstructions.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and tear, and
are therefore also required as consumables.
Wear parts*: Sanding paper
* Not necessarily included in the scope of delivery!

10. Storage

• The whole machine and all accessories must be
thoroughly cleaned.
• Store devices and accessories out of the reach
of children in a dark and dry place above freez-
ing point. The optimum storage temperature lies
between 5 and 30 °C. Store the power tool in its
original packaging.
• Do not wrap the machine into bags or covers made
of nylon or plastic, as dampness may develop.

11. Electrical connection

m The electric motor installed is connected and
ready for operation.
The connection complies with the applicable VDE
and DIN provisions.
The customer's mains power connection as well as
the extension lead used must also comply with these
regulations and the local electricity supplier regula-
tions.
Damaged electrical connection cables
The insulation on electrical connection cables is of-
ten damaged.
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage. Electrical connection cables must comply
with the applicable VDE and DIN provisions, and the
local power supply regulations.
Only use connection cables marked with H07RN.
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 220÷240 V/50 Hz.
• Extension leads up to 25 m long must have a mini-
mum cross section of 1.5 mm², and over 25 m long
must have a minimum cross section of 2.5 mm².
• The mains connection must be protected with a
max. 16 A fuse.
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Engine manufacturer; engine type
• Type of current for the motor
• Data of machine type plate
• Electrical control data

12. Disposal and recycling

The device is supplied in packaging to avoid transport
damages. This packaging is raw material and can
thus be used again or can be reintegrated into the
raw material cycle. The device and its accessories
are made of different materials, such as metals and
plastics. Take defective components to special waste
disposal sites. Check with your specialist dealer or
municipal administration!