Warranty - Spark PROFESSIONAL TV 3840 Mode D'emploi

the guide bar. Never starve the bar and chain of lu-
bricating oil. Running the saw dry or with too little oil
will decrease cutting efficiency, shorten saw chain
Problem
Unit won't start or starts but will not run.
Unit starts, but engine has low power.
Engine hesitates.
No power under load.
Runs erratically.
Smokes excessively.
X - Warranty
The guarantee period for SPARKY gas chain
saws is determined in the guarantee card.
Faults due to normal wear, overloading or improp-
er handling will be excluded from the guarantee.
Faults due to defective materials implemented as
well as defects in workmanship will be corrected
free of charge through replacement or repair.
The complaints for defective SPARKY gas chain
saws will be recognized if the machine is sent
back to the dealer or is presented to the author-
ised warranty service centre undismantled, in its
initial condition.
16
EN
life, cause rapid dulling of chain, and lead to exces-
sive wear of bar from overheating. Too little oil is evi-
denced by smoke or bar discoloration.
tRoUbLE SHootING tHE ENGINE
Probable cause
Incorrect starting procedures.
Incorrect carburettor mixture adjustment
Fouled spark plug.
Fuel filter plugged.
Incorrect lever position on choke.
Dirty spark arrester screen
Dirty air filter.
Incorrect carburettor mixture adjustment
setting.
Incorrect carburettor mixture adjustment
setting.
Incorrectly gapped spark plug.
Incorrect carburettor mixture adjustment
setting.
Incorrect fuel mixture.
Notes
Carefully read the entire Instruction Manual before
using this product.
With continuing product development changes
may have occurred which render the product
received slightly different to that shown in this in-
struction manual. The manufacturer reserves the
right to change specifications without notice.
Specifications may differ from country to country.
corrective Action
Follow instructions in the User Manual.
Have carburettor adjusted by an
authorised service centre.
Clean / gap or replace plug.
Replace fuel filter.
Move to RUN position.
Replace spark arrester screen.
Remove, clean and reinstall filter.
Have carburettor adjusted by an
authorised service centre.
Have carburettor adjusted by an
authorised service centre.
Clean / gap or replace plug.
Have carburettor adjusted by an
authorised service centre.
Use properly mixed fuel (40:1 mixture).
TV 3840