To Start Engine; Chain Brake Operational Test - Spark PROFESSIONAL TV 3840 Mode D'emploi

to StARt ENGINE

1. Slide red STOP switch (D) up for starting
(Fig. 9B). The choke has 3 positions: RUN
(A), HALF
(Fig. 9A).
2. Push the primer bulb (E) 10 times (Fig. 9C).
3. Move the choke lever (F) to
(Fig. 9D).
4. Latch throttle advance: depress latch and hold
(G) squeeze throttle trigger (H) release trigger
and then the latch (Fig. 9E).
5. Place saw on a firm, flat surface. Hold saw
firmly as shown. Pull starter rapidly 4 times.
Beware of moving chain! (Fig. 9F)
6. Move choke lever (E) to
7. Hold saw firmly and pull starter rapidly 4 times.
Engine should start (Fig. 9H).
8. Warm up for 10 seconds. Depress and release
trigger (I) for IDLE, then go to step 9 (Fig. 9I).
9. Move choke lever (E) to
If engine failed to start, repeat these instruc-
tions.
A B C
Fig. 9A
E
Fig. 9C
G
H
Fig. 9E
E
Fig. 9G
Original instructions
(B) and CHOKE
(CHOKE)
(HALF) (Fig. 9G).
(RUN) (Fig. 9J).
D
Fig. 9B
F
Fig. 9D
Fig. 9F
Fig. 9H
(C)
Fig. 9I
RE-StARtING A WARm ENGINE
1. Make sure the switch is in the ON position (I).
2. Depress the primer bulb 10 times.
3. Move the choke lever to
4. Set the throttle latch.
5. Pull the starter rope rapidly 4 times. The en-
gine should start.
6. Move the choke lever to
7. Release the throttle latch.
to StoP ENGINE
1. Release trigger and allow engine to return to
idle speed.
2. Move STOP switch down (О) to stop engine.
(Fig. 10)
NotE. For emergency stopping, simply activate
chain brake and move STOP switch down (О).

cHAIN bRAkE oPERAtIoNAL tESt

Test the chain brake periodically to ensure proper
function. Perform a chain brake test prior to initial
cutting, following extensive cutting, and definitely
following any chain brake service.
test chain brake as follows (Fig. 11):
1. Place saw on a clear, firm, flat surface.
2. Start engine.
3. Grasp the rear handle (A) with your right
hand.
4. With your left hand, hold the front handle (B),
and not chain brake lever (C), firmly.
5. Squeeze the throttle trigger to 1/3 throttle, then
immediately activate the chain brake lever (C).
E
I
Fig. 9J
(HALF).
(RUN).
О
Fig. 10
9
EN