Maintenance; Scheduled Maintenance Table - Nilfisk ALTO SCRUBTEC 545B Manuel D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be deÞ ned by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualiÞ ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank and vacuum grid with ß oat cleaning, and cover gasket check
Chemical Mixing System cleaning and draining (optional)
Squeegee blade check and replacement
Solution/clean water Þ lter cleaning
Vacuum system motor Þ lter cleaning
WET battery ß uid level check
Screw and nut tightening check
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement (only for
SCRUBTEC 545BL, 553BL and BOOST 5)
Vibration-dampers replacement (only for BOOST 5)
(1) And after the Þ rst 8 working hours.
(2) This maintenance procedure must be performed by NilÞ sk Alto authorised Service Center.
9097054000(2)2009-06 A
Bedienungsanleitung auf www.gluesing.net
Daily, after using
the machine
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
USER MANUAL
Every six
Weekly
months
(1)
ENGLISH
Yearly
(2)
(2)
(2)
(2)
21