Before Machine Start-Up - Nilfisk ALTO SCRUBTEC 545B Manuel D'utilisation

ENGLISH

BEFORE MACHINE START-UP

Brush/pad-holder installation/removal (for SCRUBTEC 545B - 545BL - 553B - 553BL)
1. According to the kind of cleaning to be performed, the machine can be equipped either with the brush (A, Fig. 2) or the pad-
holder (B) with pad (C) together with the appropriate deck.
2. Insert the ignition key (80) and turn it to "I".
3. If equipped, turn the speed adjuster (84) to idle by turning it counter-clockwise.
4. Place the brush (A) or the pad-holder (B) under the deck (18).
5. Lower the deck on the brush/pad-holder by pressing the pedal (11).
6. Turn the ignition key (80) to "I".
7. Press the brush/pad-holder switch (71).
8. Press one of the switches (83) to engage the brush/pad-holder, then release it. If necessary, repeat the procedure until the
brushes/pad-holders are engaged.
WARNING!
(Only for SCRUBTEC 545BL and 553BL): Turn the speed adjuster (84) counter-clockwise to drive the machine at
the minimum speed.
To engage the brush/pad-holder press the switch (83) which turns on the brush/pad-holder motor.
9. To remove the brush/pad-holder, the deck must be lifted by pressing the pedal (11), then press the switch (75) and wait for the
brush/pad-holder to fall on the ß oor.
Turn the ignition key (80) to "0".
Types of brushes available (for SCRUBTEC 545B - 545BL - 553B - 553BL)
450 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
14
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
Figure 2
530 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
S311334
9097054000(2)2009-06 A