Hortensus 8FT Mode D'emploi page 15

7. With stitching portion facing down lay
jumping mat inside frame and attach a
spring into one of the triangle rings on
the mat. Then attached the other end of
the spring to the frame.
9. Repeat process for the remaining springs.
Use the spring tool, as shown above.
Warning: During spring assembly, please
be careful where you place your hands
other parts of your body as connector
points.
11. Attach the remaining springs until all
springs are attached onto the frame.
13. Attach all the cover pad's strings onto the
springs.
8. Repeat STEP 7 directly across from where
you attach the first spring. Then attach
two more springs half distance between
the first two springs, directly across from
each other. This will ensure equal tension
is distributed between the springs.
10. Springs under heavy tension may require
adjacent springs to be attached at every
four or five holes. So the spring tension is
distributed equally.
12. Lay the cover pads on the outer edge so
the springs are covered.
14. Proceed to Testing the Trampoline section
of this manual before jumping on the
trampoline.