Sensors (if applicable)
Clean the recognition sensor (*8) and the presence sensors
(3) and (18*) with the brush provided.
* if applicable.
Cleaning the pressing disc
1
Press the
icon to access the user menu.
3
Press the
icon to lower the motorised pressing disc; then carry out cleaning
operations. At the end of the operation press the
menu. The pressing disc will automatically return to the resting position.
Bodywork
Use a soft cloth and cleaning products WITHOUT ammonia
or abrasives, removing any organic residue present in the
work area.
Note: Do not spray liquids into the panel slots.
When cleaning, pay close attention to the
metal support or s indicated in t e figure
(B).
(if applicable)
2
Press the
icon.
icon to go back to the previous
21 EN
18*
3
8*