Personalizing Drinks - Philips Saeco PicoBaristo SM5479 Mode D'emploi

English
10
Brewing milk-based drinks
1 Fill the water tank with tap water and fill the bean hopper with beans.
2 Remove the lid of the milk container and fill the milk container with milk (Fig. 9).
Aways use milk coming directly from the fridge for optimal results.
3 Place the lid back onto the milk container.
4 If attached, remove the hot water spout from the machine.
5 Slightly tilt the milk carafe and attach it to the machine.
6 Open the milk dispensing spout and place a cup on the drip tray.
7 To brew a milk-based drink, press one of the one-touch drink buttons. To select another type of
milk-based drink, press the MENU/SPECIAL DRINKS button, select DRINKS, scroll down to the
desired drink and press the OK button.
The machine reminds you that you have to install the milk carafe and open the milk froth
dispensing spout.
8 Directly after dispensing the milk-based drink, the display asks you if you want to perform the quick
clean procedure for the milk carafe. You have 10 seconds to activate the quick clean procedure.
Press the OK button to confirm.
Brewing coffee with pre-ground coffee
1 Open the lid and pour only one measuring scoop of pre-ground coffee into the pre-ground coffee
compartment. Then close the lid (Fig. 10).
2 Press the AROMA STRENGTH button and select the pre-ground coffee brewing function.
3 Press the OK button to confirm.
4 Select the beverage.
Note: With pre-ground coffee you can only brew one coffee at a time.
Dispensing hot water
1 If it is not attached, attach the hot water spout to the machine (Fig. 8).
2 Press the MENU/SPECIAL DRINKS button. Select DRINKS, confirm and scroll to select HOT WATER.
3 Press the OK button to confirm. The display reminds you to install the hot water dispensing spout,
press the OK button to confirm.
4 To stop dispensing hot water, press the OK button.

Personalizing drinks

Adjusting coffee and milk volume
You can adjust the volume of the drink brewed according to your taste and to the size of the cups.
1 To adjust the espresso volume, press and hold the ESPRESSO button until the display shows the
MEMO icon (Fig. 11).
-
The machine enters the programming phase and starts to brew the selected drink.
2 Press the OK button when the cup contains the desired amount of espresso.
-
The tick on the display shows that the button is programmed: every time it is pressed, the
machine brews the set espresso volume.