Safety; Important Safety Instructions - For Using Nailers - Hitachi NR 65AK2 Manuel D'instructions Et De Sécurité

English

IMPORTANT SAFETY INSTRUCTIONS - FOR USING NAILERS

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
General
To reduce the risks of electric shock, fi re, and injury to persons, READ ALL THE INSTRUCTIONS BEFORE
USING THE TOOL.
1. OPERATORS AND OTHERS IN WORK AREA
MUST WEAR EYE PROTECTION (SAFETY
GLASSES WITH SIDE SHIELDS).
When operating the Nailer, always wear
safety glasses with side shields, and
make sure others in work area wear
safety glasses, too.
Safety glasses must conform to the
requirements of American National
Standards Institute, ANSI Z87.1 and provide
protection against fl ying particles both from the front
and side.
Ordinary eyeglasses do not provide adequate
protection.
The employer must enforce the use of safety glasses
by the Nailer operator and others in work area.
2. NEVER USE REACTIVE GASES OR OTHER
BOTTLED GASES. EXPLOSION MAY OCCUR.
Never use reactive gases such as
oxygen, combustible gases or any other
bottled gases as a power source for the
Nailer.
Use of the above gases is dangerous, as
the Nailer will explode.
Use only clean, dry, regulated compressed air.
3. NEVER DRIVE NAILS
CONCRETE.
YES
• pre-punched holed
metal
• wood
If the nail is driven into metal or concrete directly, it
could ricochet and hurt yourself as well as others.
4
000Book̲NR65AK2̲NA̲lowes.indb 4 000Book̲NR65AK2̲NA̲lowes.indb 4

SAFETY

DANGER
INTO METAL OR
NO
• no-holed metal
• concrete
4. ALWAYS BE AWARE OF POSITION OF FIRING
HEAD.
YES
work surface
When the fi ring head is pointed away from work
surface, injuries can occur.
5. KEEP THE TOOL ALIGNED WITH THE PRE-
PUNCHED METAL HOLE WHEN FIRING.
YES Zone
80 deg.
NO
50 deg.
Zone
WOOD
Metal hole
Insert the nail point in direct alignment to the pre-
punched metal hole.
Do not align with the surface at an angle of less than
50 degrees.
NO
NO
50 deg.
Zone
METAL
2018/03/09 15:49:13 2018/03/09 15:49:13