Instructions For Assembly - Christopeit Sport SP 10 Mode D'emploi

Instructions for assembly

Before you start assembly, it is essential that you follow our recom-
mendations
and safety instructions. Take out all parts out of the carton and place
them separately on the fl oor. Some parts are pre-assembled.
Step 1:
Installation of centre support (3) and rear stabilizer (2) at main base
(1).
1. Place the main base (1) and rear stabilizer (2) together on an even fl oor
and screw it tightly by using bolts M10x65 (16), curved washers 10//22
(17) and self locking nut M10 (18).
2. Put the centre support (3) onto the main base (1) and screw them tightly
by using carriage bolts M10x60 (24), bolt M10x70 (91), washers 10//20
(20), curved washer 10//22 (17) and self locking nuts M10 (18).
3. Put the stabilizer (82) onto the appropriate position of centre support (3)
and screw it tightly by using bolts M10x70 (91), washers 10//22 (17) and
self locking nuts M10 (18).
4. Place the back pad (34) with back side against the centre support (3) and
screw it tightly by using screws M10x65 (16) and washers 10//22 (17).
5. Put the pulley unit (31A) together as fi gure shows. That means: Put on
each screw (76) a washer 10//20 (20), a plastic ring (75), a cable slide
(22), a pulley (23) and again a plastic ring (75) and a cable slide (22) and
put the screw (76) through the centre support (3). Tighten the screw (76)
with washer (17) and nut (18), so that the pulley (23) can move easy.
6. Insert a pulley (23) into the pulley holder of main base (1). Put a washer
(20), a plastic ring (75) and a cable slide (22) onto the screw M10x60 (21),
put the screw (21) through the pulley holder with pulley (23) and tighten it
with washer (20) and nut (18) so that the pulley (23) can move easy. Then
put a screw cap (19) onto all screw heads (16+21+91) and nuts (18).
19