Assembly Instructions - Christopeit Sport Mini Trampolin T200 Notice De Montage Et D'utilisation

Assembly Instructions

Remove all the separate parts from the packaging, lay them
on the floor and check roughly that all are there on the base
of the assembly steps. For assembly you need approx. 40 min.
time, enough empty area, muscle power and if possible, a sec-
ond person for a more easy build up.
Step 1:
Assembly of main frame (1+2).
1. Put the frame part with grip holder (1) and one frame part (2)
together. Therefore press the steel button to push the parts
into the right positon and lock up these parts by push out the
steel button in provided hole.
2. Put together all frame parts (2) in the same way until the base
frame is complete pre-assembled.
Step 2:
Preassembling of jump mesh (12).
1. Place the jump mesh (12) on the floor inside of the pre-assembled frame
and fold in the surrounding from jump mesh.
2. Lead the 6 short elastic ropes (10) located at the edges of jump mesh
(12) downside over the frame feet to upper plastic holder (8) and hang
into provided position.
Step 3:
Assembly of the first two elastic ropes (11).
1. Take one elastic rope (11) and hang on the end into the provided plastic
holder (8) at side (A) in a save way. Lead the other end of elastic rope
as shown in picture through the first loop of jump mesh (12). Then over
the frame downwards through the second loop of jump mesh.
2. Take a second elastic rope (11) and start the assembly parallel on
opposite side (B) as point 1 describes. Pull powerful the elastic rope
(11), so that the elastic rope come through the loop of jump mesh as
most as possible. Lead the elastic rope again over the frame downwards
and through the next loop. To secure that the elastic rope keeps pulled
position put a clip at the elastic rope near the loop. After every loop
assemble pull the elastic rope powerful and change clip to next loop
position. After 2-3 loops assembled continue the assembly on opposite
side (A) in the same way and do this until the end of elastic rope is fully
assembled. The hook with handloop helps to pull the end of elastic rope
if you cannot hold it powerful by hand. With help of the hook you can
finish the assembly of the first two ropes and secure in provided plastic
holder (8).
11