Christopeit Sport Mini Trampolin T200 Notice De Montage Et D'utilisation page 12

Step 4:
Assembly of further elastic ropes (11).
1. If the elastic ropes No. 1+2 are fully assembled you can install the next
two elastic ropes (11) in the same way parallel on side (C+D) as step 3
describes. If the assembly get more and more complete it is necessary
to pull more powerful the elastic rope to get right position. After elastic
ropes No. 3+4 are assembled, do it same way with elastic ropes No.
5+6 on side (E+F).
Step 5:
Assembly of surroundings of jump mesh (12).
1. Fold out the surrounding from jump mesh (12) and pull the short small
elastic ropes (10) from the corners from outside over the frame feet to
cover the frame completely.
Step 6:
Assembly of hand grip (3).
1. Put the enlarge tube (5) with connection tube (4) together, so that the
holes and threats are align. Put on every screw M8x15 (14), one spring
washer (16) and one washer (15) and screw both parts firmly. Place the
screw cover (20) over the screw connection point.
2. Put the hand grip (3) onto the enlarge tube (5), so that the holes and
threats are align. Put on every screw M8x15 (14), one spring washer
(16) and one washer (15) and screw both parts firmly. Place the screw
cover (20) over the screw connection point.
3. Insert the hand grip (3) with connection tube (4) into the provided holder
of the frame (1) and secure at the desired position by screwing in the
rapid-action lock (13).
(Note: To screw in the rapid-action lock (13), the threaded hole in the
hand grip holder (1) and one of the holes in the connection tube (4) must
be aligned. The setting of the hand grip (3) can be adjusted as desired
later. For this, the rapid action catch (13) must be loosened by only a
few revolutions, the cap of the lock must be pulled away and the hand
grip (3) adjusted. Then secure the new setting by tightening the rapid
action catch (13).
12