Christopeit Sport SP 10 Mode D'emploi page 21

Step 3:
Installation of end tube (7) and top cross beam (6).
1. Place the end tube (7) onto the ends of guide bars (5) and screw them
together by using screw M10x25 (85) and curved washer 10//22 (17).
2. Insert a pulley (23) into the pulley holder of top cross beam (6). Put a
washer (20), a plastic ring (75) and a cable slide (22) onto the screw
M10x60 (21). Then put the screw (21) through the pulley holder with pulley
(23) and put a plastic ring (75) and a cable slide (22) onto the screw (21)
again. Tighten it with washer (20) and nut (18) so that the pulley (23) can
move easy.
3. Screw tightly the top cross beam (6) at end tube (7) by using screw
M10x65 (16), curved washers10//22 (17) and nut (18). Then put a screw
cap (19) onto all screw heads (16+21+87) and nuts (18).
4. Put the top cross beam (6) in appropriate position onto the centre support
(3) and tighten it fi rmly by using screw M8x20 (87), screw M10x65 (24),
washers (17+64), bracket (88) and nut (18+49).
21