Trial Operation - Invacare Aquatec Pure Bidet Manuel D'utilisation

Following parts are needed for the assembly of the
flush-mounted water flow but are not included in
the scope of delivery:
• Tube A
• Nut B
Available at your specialised dealer.

4.3 Trial operation

Leakage test
A
1. Open the shut off valve A completely by turning
counterclockwise.
2. Check for any water leakage on the connection hoses,
tighten if necessary.
Connecting the power plug
1. Read and follow the safety information regarding
electrical safety, → 2.1 Safety information, page 3 .
2. Connect power plug to a suitable power source.
WARNING!
Electric shock hazard
– Do not turn over or move the unit after power
connection.
3. If the power indication light is not turned on after the
power plug connection, press any button except HI/LO,
FR/BK buttons of the remote control, then power goes
on.
Checking the key functions
B
C
1. Place one hand on the seat sensor A.
2. With the other hand press "CLEANSING / STOP" on the
unit control panel B or "CLEANSING" or "BIDET" on the
remote control.
• Water sprays out of the nozzle. Cover the nozzle
with your free hand C to prevent water spattering
out.
1590625-F
A
4.4 Disassembly
Follow the below instructions if in need of detaching the
unit for removal.
1. Disconnect the power plug.
2. Close the water supply by turning the shut off valve
clockwise.
3. Drain the toilet water tank completely by flushing.
4. Disconnect the PVC flexible hose from the T-valve.
5. Lift the device slightly and pull it forwards out of the
holder.
6. Unfasten the drain plug A underneath the unit and drain
the water completely out of the water tank.
7. Disconnect the PVC flexible hose and T-valve.
8. Connect the water-supply hose from the water tank to
the shut off valve.
9. Open the shut off valve by turning counterclockwise.
10. Check the connections for any leakages, tighten if
necessary.
11. Reinstall the original seat and lid to the toilet.
5 Usage
5.1 Safety information
CAUTION!
Risk of Injury or Damage to Property
– Before use, verify the general functionality of
the product.
– Before use, check the product for any defect.
– Do not use a defective product.
A
7