Connecting Electrical Power To The Radio Link - Dometic Waeco PerfectView Accessory Instructions De Montage Et De Service

Connecting electrical power to the radio link

 Transmitter module: Make sure you can lay the connection cable to the camera.
 Receiver module: Make sure you can lay the connection cable to the monitor.
NOTE
I
Pictures and sound are sent from the transmitter module to the receiver module.
To ensure flawless functioning, you need to check whether the wireless trans-
mission is stable before final installation.
To perform the installation, proceed as follows:
➤ Attach the modules temporarily to the planned installation location.
➤ Install the rear view video system if you have not already done so.
➤ Start up the rear view video system.
If the camera image transmission is stable (two or three reception bars at the top right
of the monitor), you can complete final installation of the two modules.
If faults occur (only one reception bar or a yellow warning triangle on the top right of
the monitor) turn or move the transmitter or receiver module slightly and conduct fur-
ther tests.
Attaching the modules (fig. 8, page 6)
To do this, proceed as follows for each module:
➤ Hold the module at the chosen location and mark the four points for drill holes.
➤ Drill holes with a Ø of 4 mm at each of the points you just marked.
➤ Screw the module on with M5 x 20mm self-tapping screws.
Fixing the antennas (fig. 9, page 6)
NOTE
I
Always align the antennas in the same direction, for example, both vertically.
This improves the transmission performance.
➤ You can glue the antennae on the corresponding module.
7 Connecting electrical power to the radio link
7.1 General notes on laying cables
NOTE
I
 As far as possible, use original ducts for laying the cables, or other suitable
options such as panelling edges, ventilation grilles or dummy plugs. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
 Cables and connections that are not properly installed will cause malfunctions
or damage to components. Correct installation of cables and connections en-
sures lasting and trouble-free operation of the retrofitted components.
26
VT100DIG
EN