Connecting The Camera - Dometic Waeco PerfectView CAM24 Notice De Montage Et D'utilisation

Mounting the camera
➤ Secure the camera guard with the four M3 x 8 mm screws in the slots
(Fig. g, page 7).
Note!
The six screws are only tightened when you have aligned the cam-
era (see the "Checking the function and setting the camera" chap-
ter on page 35).
To do this you must first install and connect a monitor (see principle
circuit diagram Fig. j, page 7).
8.3

Connecting the camera

Note!
Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable
(Fig. 0 A, page 5).
Tip!
To minimise corrosion in the plug, apply a small amount of grease
– such as pin grease – inside the plug.
Caution!
The plug connections of the extension cable do not offer any
protection against water penetration. It is essential that you wrap
the connection with the sealing tape supplied (Fig. 0 B, page 5).
Note!
Additional extension cables are available on request (see the "Ac-
cessories" chapter on page 27).
34
PerfectView CAM24, CAM27