Tecno-gaz Europa B evo Mode D'emploi page 51

12. PROGRAMMING AND PARAMETERS DISPLAY
12.1 LANGUAGE SELECTION
12.2 HOURS SELECTION
12.3 MINUTES SELECTION
12.4 SECONDS SELECTION
12.5 DATE SELECTION
12.6 MONTH SELECTION
12.7 YEAR SELECTION
12.8 VISUALIZE ATMOSPHERIC PRESSURE
12.9 WATER LOADING SELECTION
13. SOLUTION TO OPERATION PROBLEMS
13.1 AUTOCLAVE DOES NOT DRY CORRECTLY
13.2 AUTOCLAVE CHAMBER BECOMES WHITE
13.3 AUTOCLAVE CHAMBER PRESENTS GREEN STAINS
13.4 INTERRUPTION OF THE STERILIZATION CYCLE
13.5 AUTOCLAVE DOES NOT RECEIVE COMMANDS
13.6 AUTOCLAVE PRINTER DOES NOT PRINT
13.7 STAINS ON INSTRUMENTS
14. DEMINERALIZER
14.1 SET OF DEMINERALIZER SYSTEM
14.2 CONNECTION AND PLUG OF DEMINERALIZER SYSTEM
14.3 CHANGE RESINS OF FILTER
15. STANDARD STERILIZATION PROCEDURE
16. INSTRUCTIONS FOR AUTOCLAVE SHIPPING
17. PROCEDURES FOR SERVICE AND ASSISTANCE
18. GUARANTEE
THE MANUFACTURER RESERVES THE RIGHT TO CARRY OUT IMPROVING TECHNICAL
CHANGES WITHOUT ANY PREVIOUS NOTICE. THIS MANUAL IS A SOLE PROPERTY OF
TECNO-GAZ S.P.A. AND CANNOT BE COPIED, REPRODUCED OR TRANSFERRED TO THIRD
PARTIES WITHOUT THE WRITTEN AUTHORISATION OF TECNO-GAZ S.P.A.
ENGLISH
3