Additional Documents For Safety; Use According To Destination; Basic Requirements For A Safe Use; Unauthorized Use - Giorgio Bormac 8+ Série Manuel D'utilisation

• Additional documents for safety

Following documents provide the operator with additional information to work safely with the
measurement system:
Operating manual for electrochemical sensors
•
• Safety data sheets for buffer solutions and other maintenance solutions (e.g. storage)
• Specific notes on product safety.

• Use according to destination

This instrument is designed exclusively for electrochemical measurements both in laboratory. Pay attention
to the technical specifications shown in the INSTRUMENT FEATURES / TECHNICAL DATA table; any other use
is to be considered unauthorized. This instrument has left the factory in perfect technical and
safety conditions (see test report in each package). The regular functionality of the device and the
operator safety are guaranteed only if all the normal laboratory safety standards are respected and if all the
specific safety measures described in this manual are observed. All the notes, indications and
recommendations contained in this manual are also valid for the independently controlled magnetic stirrer
that can be found in combination with some sales codes for the instruments.

• Basic requirements for a safe use

The regular functionality of the device and the operator safety are guaranteed only if all the following
indications are respected.
The instrument can be used in accordance with the specifications mentioned above only.
•
Use the supplied power supply only. If you need to replace the power supply, contact your local
•
distributor.
The instrument must operate exclusively in the environmental conditions indicated in this manual.
•
• Neither the instrument nor the magnetic stirrer should be opened by the user for any reason.
Do this only if explicitly authorized by the manufacturer.

• Unauthorized use

The instrument should not be put into operation if:
• It is clearly damaged (for example due to transportation);
• It has been stored for a long period of time in adverse conditions (exposure to direct light, heat sources
or places saturated by gas or vapours) or in environments with conditions different from those
mentioned in this manual.

• Device Maintenance

If used correctly and in a suitable environment, the instrument does not require maintenance procedures.
It is recommended to occasionally clean the instrument case with a damp cloth and a mild detergent. This
operation must be performed with the instrument off, disconnected from the power supply and by
authorized personnel only. The housing is in ABS / PC (acrylonitrile butadiene styrene / polycarbonate). This
material is sensitive to some organic solvents, for example toluene, xylene and methyl ethyl ketone (MEK).
If liquids get into the housing, they could damage the instrument. In case of prolonged non-use of the
device, cover the BNC connectors with the special cap supplied with. Do not open the instrument housing:
it does not contain parts that can be maintained, repaired or replaced by the user. In case of problems with
the instrument, contact your local distributor. It is recommended to use original spare parts only. Contact
your local distributor for information. The use of non-original spare parts can lead to malfunction or
permanent damage to the instrument. Moreover, the use of spare parts not guaranteed by the supplier can
be dangerous for the user himself. For the maintenance of the electrochemical sensors, refer to the
documentation present in their packaging or contact the supplier.
UM Serie 880 EN rev.2 30.07.2020
6
EN