Keyboard; Installation; Supplied Components; Start Up - Giorgio Bormac 8+ Série Manuel D'utilisation

• Keyboard

Quick-Manual key *
Directional keys
to scroll through
menus and
manage data
logging
Mode key to scroll
measurement parameters
8+ Series keys

Installation

• Supplied components

In the BASIC versions, it is always included inside the package:
Instrument, 12V / 1000mA power supply, electrode holder, 1m S7 / BNC connection cable, NT55
temperature probe, single-dose bottle buffer solutions, USB cable, (external keyboard only for 80+ series),
multilingual user manual and test report.
In the STIRRER versions, it is always included inside the package:
Instrument, 12V / 1000mA power supply, independently controlled magnetic stirrer with connection cable,
metal anchors, electrode holder arm, 1m S7 / BNC connection cable, NT55 temperature probe, buffer
solutions in single-dose bottle, USB cable, (external keyboard only for 80+ series), multilingual user manual
and test report

• Start up

• Place the instrument on a flat, stable laboratory bench with adequate front and side accessibility. It is
recommended to place the instrument at a distance of not less than 20 cm from overlying and
surrounding parts.
The positioning carried out in this way eliminates the residual risk of possible minor damages caused
by manual handling of the loads.
• Make sure that the instrument and the surrounding space are correctly illuminated
In the STIRRER versions, using a Phillips screwdriver, unscrew the metal brackets located under the
•
stirrer and attach them to the device. Then insert the electrode holder arm on the pin. Connect the
instrument ("Stirrer" connector) at the stirrer with the special cable provided.
• In the BASIC versions, assemble the holder next to the instrument by assembling the electrode holder
arm into the base pin.
The instrument is not designed to be used in atmospheres where hazardous materials are present.
•

• Connection of the power supply

Check that the electrical standards of the line on which the instrumentation is to be installed comply
•
with the voltage and operating frequency of the instrument (technical datasheet).
Use the original power supply only.
•
Connect the power supply plug to the connector on the rear panel of the instrument indicated with
•
the icon .
• Connect the power supply to an electric socket easy to reach.
UM Serie 880 EN rev.2 30.07.2020
80+ Series keys
9
On-Off key to turn
the device on and off
Meas / Cal key to return to
measurement mode and to
start the calibration
Enter / Menu key to confirm
the selected values and enter
setup menu from
the measurement mode
EN