Key Functions; Inputs / Outputs Connections - Giorgio Bormac 8+ Série Manuel D'utilisation

• Key functions

Key Push Functions
Press to turn the device on or off.
Short
In measurement mode press to scroll through the parameters:
•
•
Short
•
pH/Cond  pH  ORP  analogic pH  Ion*  Cond  TDS  Sal  Res*
* parameters available only for 80+ Series
In calibration, setup and recall memory mode press to return in measurement
Short
mode.
In measurement mode press and hold to start the calibration.
Long (3s)
CAL
In measurement mode press to enter in setup menu.
In setup menus, press to select the program and / or the desired value.
Short
During calibration, press to confirm the value.
MENU
In setup and subsetup menu press to scroll.
In the submenu of the setup press to change the value.
In memory recall mode press to scroll the saved values.
In MTC mode and customer calibration press to change the value.
Short
M+/Print: In measurement mode press to save or print the value (maual data
logger) or start and finish the recording (automatic data logger).
RM: In measurement mode press to recall saved data.
In measurement mode, press and hold one of the keys to change the temperature
to MTC mode (manual compensation, without probe). When two darts appear
Long (3s)
alongside the value, the user can change the temperature value by entering the
correct one.
In measurement press to display the quick manual with the calibration
Short
instructions.
The correct use of the function keys and the attention in pressing them, given the small size, eliminates the
residual risk of minor damages, not probable, caused by simultaneous pressing of the keys; before each use,
check that pressing the keys has the corresponding effect on the display.

• Inputs / Outputs connections

Use only original accessories guaranteed by the manufacturer.
If necessary, contact your local distributor. The BNC connectors at the time of sale are protected by a plastic
cap. Remove the cap before connecting the probes.
* function available only for 80+ Series
BNC for pH, ORP, Ion electrodes
Connection for stirrer
(independent control)
RCA for temperature
probe for pH
Banana 4mm for
reference electrode
RCA for temperature probe for Cond
UM Serie 880 EN rev.2 30.07.2020
pH80+DHS : pH  ORP  analogic pH  Ion*
Cond80+: Cond  TDS  Sal  Res*
PC80+DHS:
PC80+DHS back panel
Read the manual before
proceeding to connect
the probes or peripherals
11
BNC for Cond sensor
USB type A* for keyboard
Connecting to the
mains power supply 12V
RS232 for printer
connection
USB type B for PC link
EN