Setup Menu; Temperature Measurement Atc - Mtc - Giorgio Bormac 8+ Série Manuel D'utilisation

Reading this manual before each use eliminates the residual risk of possible and significant errors in the
interpretation of the data on the display. It is therefore recommended that the user carefully read the
manual to correctly use the instrument and correctly interpret the information on the display. All this will
ensure that the risk of misinterpretation goes from possible to highly improbable.

Setup Menu

In measurement mode press "
•
want to change by moving with the directional keys and confirm with
• pH8+DHS: pH  Data Logger  Configuration
pH80+DHS:
•
Cond8+ and Cond80+:
•
• PC8+DHS: pH  Cond/TDS  Data Logger  Configuration
PC80+DHS:
•
In the selected menu, move between different programs using directional keys and press
•
select what you want to change.
Using and keys choose the option you want or change the numeric value and confirm with
•
key.
• Press key to return in measurement mode.
Note: External keyboard for 80+ Series can be used to scroll through the different setup menus
Temperature Measurement ATC – MTC
ATC : The direct measurement of the sample temperature for all parameters is carried out through the
•
NTC 30KΩ probe, which can either be integrated into the electrode or external.
MTC : If no temperature probe is connected, this must be manually inserted: press and hold
•
until two little arrows appear alongside the value, adjust the value using again directional keys,
then press key to confirm.
UM Serie 880 EN rev.2 30.07.2020
MENU" key to enter in SETUP mode, choose the parameter that you
pH  Ion  Data Logger  Configuration
Cond/TDS  Data Logger  Configuration
pH  Ion  Cond/TDS  Data Logger  Configuration
13
.
key to
or
EN