Maestro Kit System Expandability; Programming Art. 4660Kc - Comelit MT KIT 13 Manuel Technique

MAESTRO KIT SYSTEM EXPANDABILITY

The diagrams MK/EN/100C and MK/EN/101C on pages 78 and 80
show a possible system configuration for managing up to a max. of
30 MAESTRO KITS with one Art. 4660C placed, for example, at
the entrance of a residential complex.
With these system diagrams it is possible to call one of the
MAESTRO KITS from the main entrance equipped with Art. 4660C.
In this configuration it is necessary to program the pushbuttons of
Art. 4660C on Art. 4875KC or 4876KC as described in the following

Programming Art. 4660KC

Fig. 1
Fig. 1A
1. On the terminal board of module Art. 4660KC connect the
power supply to ~~, set the switch to the programming
position (red) (Figure 1A).
Connect the terminal block to module Art. 4660KC assembled
as shown above.
NOTE: For connection between the terminal block and
module Art. 4660KC during the programming stage it is
possible to use the cable Art. 3309, available as an optional
accessory (figure 2).
2. Set the Dip switch located on the back of the audio-video
module, with the same code assigned to the door-entry phone
or monitor according to the alignment described in the
programming table on page 33.
procedure, and the brackets 5914KC with the corresponding code
(see table on page 33).
For further information on integration of the MAESTRO KITS in
Simplebus systems and for programming the main entrance panel
(Art. 4660C), refer to the Simplebus Color catalogue (Catalogue
no. 102), the MT/SBC/01 technical manual and the FT/SBC/04 or
FT/SBC/01 technical sheet.
Fig. 2
Fig. 2A
3. Press the pushbutton to be associated with the door-entry
phone call or monitor. A confirmation tone signals that
programming has taken place.
4. At the end of programming, set the switch to standby (white)
(figure 2A).
MT KIT 13
Art. 3309
39
MT KIT 13