Style Door-Entry Phone Art. 2610 - Comelit MT KIT 13 Manuel Technique

Style door-entry phone Art. 2610

8
2
1
3
3 4
6
5 6
8
7
7
9
Elegance door-entry phone with additional functions and
pushbuttons and intercom service.
By means of special setting, Art. 2610 can manage intercom calls
and other additional functions (see summary table on page 34).
The door-entry phone must always be mounted using Art.
1214/2C as shown in the MK/DC connection diagram on page
72.
1. 3-position ringtone/Privacy service selector:
High position: Max. ringtone volume.
Middle position: Medium ringtone volume.
Low position: Privacy function activation
(Privacy service means exclusion of the call ringtone from
the external unit and switchboard; activation of the Privacy
function is signalled by a red indicator appearing in the top
right-hand corner).
2. Privacy function indicator.
3. Signalling LED (available as standard).
4. Door request exit button
5. Pushbutton 1 available as standard (programmable with
various functions, see table on page 37. Factory-set for
Generic actuator function).
6. Pushbutton 2 available as standard (freeable, or
programmable with various functions, see table on page
37).
Factory-set to switchboard call.
7. Optional pushbuttons C. NO. or LEDs (MAX 3) for
additional functions. (A)
8. Interchangeable cover Fig. 7 page 26.
9. Pushbutton memo label for indicating the door-entry phone
pushbutton functions (to be applied under the
interchangeable cover, Fig. 7 page 26).
10. Door-entry phone handset (lift the handset to start
communication).
(A) Pushbutton available with optional card Art. 1626.
Display LED available with optional card Art. 1627.
1
2
4
5
7
10
9
.
11. System connection terminals:
L L bus line connection.
CFP CFP floor door call input.
P2 C2 pushbutton P2 C terminals. NO. 24V 100mA dedicated
to various services (remove CV2 and CV3).
S+ S- Terminals for call repetition device.
12. SW3 Jumper for selection of Simplebus 1 and Simplebus 2
mode.
13. CV3 CV2 Jumper to be removed for pushbutton P2 C. NO.
14. Dip switch U2 for setting user code (see table on page 33).
15. Dip switch U4 for programming pushbuttons P1 and P2 (see
table on page 37).
16. Microphone volume control trimmer.
Clean using a damp cloth. Do not use alcohol or other aggressive
products.
MT KIT 13
16
14
15
13
11
12
29
MT KIT 13