Installation Instructions Art. 4875Kc, 4876Kc - Comelit MT KIT 13 Manuel Technique

Installation instructions Art. 4875KC, 4876KC

• Wall-mount the box 160÷165
cm above the level of the
finished floor, in an area where
it is easy to view the visitor.
If possible it should not point
into the sun or at other direct
light sources (lamps, reflective
surfaces, etc.)
• Fix the frame on the flush-
mounting box using the 2
screws supplied.
• Insert the terminal block and
connect the wires according to
the diagram.
• Fit the snap-on module onto
the terminal and fix it with the 2
screws provided.
• Remove the stainless steel
C
M I
3
2
• Alternative microphone
1
4
5
• To remove the name tag
1
• After adjusting, fix the trim by
OPEN
2
3
CLOSE
MT KIT 13
front to carry out volume
adjustments and adjust the
camera.
NOTE Loosen the four screws
slightly to unlock the camera
and allow adjustment.
position.
holder, insert the tip of a
screwdriver into the middle
opening and extract it.
means of the 2 bottom screws.
NOTE To remove the trim,
undo the 2 bottom screws,
turning max. 360°.
23
MT KIT 13