Style Door-Entry Phone Art. 2610 - Comelit PLANUX MT KIT 14 Feuille Technique

Style door-entry phone Art. 2610

2
1
4
3
6
5
7 8
9
Elegance door-entry phone with additional functions and
buttons and intercom service.
Art. 2610 can be used (by means of the relevant settings) to manage
intercom calls and other additional functions.
The door-entry phone must always be mounted using Art. 1214/2C,
as illustrated in the PXK/DC wiring diagram on Page 73.
1 3-position ringtone/Privacy service selector:
High position: Maximum ringtone volume.
Middle position: Medium ringtone volume.
Low position: Privacy function activation
(Privacy service means exclusion of the call ringtone from the
external unit and switchboard; activation of the Privacy function is
signalled by a red indicator appearing in the top right-hand
corner).
2 Privacy function indicator.
3 Signalling LED (available as standard).
4 Lock-release button A .
5 Button 1 available as standard (programmable with various
functions, see table on Page 36. Factory-set for Generic actuator
function).
6 Button 2 available as standard (programmable with various
functions, see table on Page 36).
Factory-set for the Switchboard call function.
7 Buttons C. NO. or LEDs (MAX 3), optional, for additional functions.
(A)
8 Interchangeable cover Fig. 9 Page 30.
9 Button memo label on which the door-entry phone button
functions can be indicated (to be applied to underneath the
interchangeable cover) Fig. 9 Pag. 30.
10 Door-entry phone handset (lift the handset to start
communication).
11 System connection terminals:
L L Bus line connection terminals.
CFP CFP Floor door call input.
P2 C2 Terminals for button P2 C. NO. 24V 100mA dedicated to
various services (remove CV2 and CV3).
S+ S- Terminals for call repetition device.
12 SW3 Jumper for switching between Simplebus 1 and Simplebus 2
modes.
13 CV3 CV2 Jumpers to be removed in order to have button P2 C.
NO.
14 Dip switch U2 for setting the user code (see table on Page 31).
15 Dip switch U4 for programming buttons P1 and P2 (see table on
Page 36).
16 Trimmer for adjusting the microphone volume.
(A)Button available with optional card Art.1626.
Display LED available with optional card Art. 1627.
Clean using a damp cloth. Do not use alcohol or other
aggressive products.
MT KIT 14
16
15
29 MT KIT 14