Internal Units; Art. 6101; Art. 6114Kc - Comelit PLANUX MT KIT 14 Feuille Technique

Group S.p.A.

INTERNAL UNITS

Art. 6101

Technical characteristics - Colour monitor Art. 6101
1 Microphone.
2 LCD colour display; displays the monitor menu and the images
from the external unit or other cameras (if present).
3 Speaker.
4 Audio key.
5 Door lock key.
6 Navigation keys.
7 General internal call key (programmable).
8 Generic actuator key (programmable).
9 Self-ignition key (programmable).
10 Privacy/Doctor function key.
NOTE If, after a key is pressed, it flashes for 4 seconds, this means
the function is not available or the system is busy.
Navigation keys
Menu key
Use this key to access and exit the menu, and to go back one level in
the menu.
If left idle, the monitor exits menu mode automatically after 15
seconds.
Confirm key
Confirms the selection made and provides access to the next menu
level.
Navigation keys
Use these keys to scroll through the headings and modify the value
of the selected heading.
Door entry monitor keys and functions
Audio key
Activates or de-activates conversation with the external unit.
The LED flashes to indicate that a call has been received. The LED
illuminates to indicate that a conversation is in progress.
Door lock key
Use this key to open the corresponding door lock.
The blue LED flashes to indicate that a call has been received.
The red LED flashes to indicate that the door is open (see BK/OAC
variant, Page 74).
Programmable key 1 *
Factory-set to Switchboard call.
MT KIT 14 24
Programmable key 2 *
Factory-set to Generic actuator.
Self-ignition key *
Factory-set to Self-ignition.
Privacy / Doctor key
• The Privacy function disables calls from the external unit and
switchboard.
• The Doctor function enables automatic activation of the lock-release
in response to a call from the external unit.
• The Privacy + Doctor function, as well as disabling the door-entry
phone ringtone in the same way as the Privacy function, also
enables automatic activation of the lock-release in response to a call
from the external unit.
The red LED indicates that the selected function is active.
* The key may be programmed for the following functions:
Switchboard call, Generic actuator, Actuator with code (activation
of Art. 1256), Remote camera control (activation of Art. 1259C),
General internal call, Two-family call.

Art. 6114KC

5
3
1 CN4 CN5 Monitor-bracket connectors.
2 Terminal block for system connection.
S- S+ Terminals for call repetition device.
CFP CFP Floor door call input.
L L Bus line connection terminals.
- + Power supply terminals.
+VS Local power supply terminal.
3 JP1 Jumper for setting bracket as Main or Secondary.
4 CV5 Jumper for video closure.
5 S1 User address programming dip switch.
2
1
4