Cutting Tips - Ryobi RLT3725CH-A Manuel D'utilisation

GB
F E
OPERATION
left, left to right with the line parallel to the ground and
proceeding forward slowly. Keep the trimmer inclined
by about 30°.
On RLT3725CH-A model, you can put your arm on
■
the crutch to achieve a more comfortable position.
High grass should be cut in layers, always begin from
■
the top. The cuts should be short.
Do not cut damp or wet grass. Dry grass will give
■
excellent results.
Always let the line rotate at top speed. Do not work in
■
such a way as to overload the trimmer.
Avoid wearing the line out quickly by knocking against
■
hard objects (stones, walls, fences etc.).
Never pass the line trimmer over the electric cable
■
while the line trimmer is running; make sure the cable
is always in safe position behind your back.
To switch off the line trimmer, simply release
■
the trigger.
CAUTION
After switching off, the nylon line will continue to
rotate for a few more seconds.

CUTTING TIPS

Lawn Edging (Fig. 7)
When the trimmer is used for lawn edging, pull the
rotating release (12) and rotate the trimmer head 180 º.
Adjustable angles (on RLT3725CH-A only) (Fig. 8)
On RLT3725CH-A model, press on the foot pedal (14)
and the trimmer head (13) can be turned to achieve
different angles for cutting less accessible or more
awkward places. Five different angles can be selected.
SAFETY GUARD LINE TRIMMING CUT-OFF
BLADE
This trimmer is equipped with a line trimming cut-off blade
on the safety guard. For best cutting, advance fresh lines
by gently tapping the bump head (19) on the ground.
Fresh lines will be released from the bump head and
trimmed to optimum length by the cut-off blade. Advance
line whenever you hear the engine running faster than
normal and when it is apparent the line is worn or broken.
This will maintain best cutting performance.
I P NL S DK N FIN
English
MAINTENANCE
REPLACING THE CUTTING LINE
WARNING
Use of line other than the original 1.4 mm.
monofilament cutting line could cause serious
personal injury or damage to the trimmer.
WARNING
Make sure the trimmer head stops rotating when
you release the trigger. Contact with a rotating
trimmer head could cause personal injury.
Unplug the trimmer.
■
Press in both lock tabs (in between the line eyelets),
■
then remove the spool cover (Fig. 9).
Remove the empty spool and replace with a new
■
spool (Fig. 10).
Insert the lines into the eyelets on the bump head.
■
Replace the spool cover securely (Fig. 11).
■
Press the bump button (17) and advance the line
■
manually until it can be trimmed to length by the
cut-off blade.
14
GR TR EST LT LV