Ryobi RLT3725CH-A Manuel D'utilisation page 18

GB
F E
SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a qualified service technician.
For service we suggest you return the product to your
nearest AUTHORIZED SERVICE CENTRE for repair.
When servicing, use only identical replacement parts.
WARNING
Observe all normal safety precautions related to
avoiding electrical shock.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly
and understand completely the operator's
manual. Save this operator's manual and review
frequently for continuing safe operation and
instructing others who may use this product.
WARNING
The operation of any power tool can result in
foreign objects being thrown into your eyes, which
can result in severe eye damage. Before beginning
power tool operation, always wear safety goggles
or safety glasses with side shields and a full face
shield when needed. We recommend Wide Vision
Safety Mask for use over eyeglasses or standard
safety glasses with side shields. Always use eye
protection.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
RLT3725CH-A
Voltage
Nameplate Power
No Load Speed
Cutting Line
Max.Cutting Path
Sound Power Level
Vibration
- Front Handle
- Rear Handle
RLT3725-A
Voltage
Nameplate Power
No Load Speed
Cutting Line
Max.Cutting Path
Sound Power Level
I P NL S
230V~50 Hz
370 W
11,000 min
1.4 mm
250 mm
94 dB(A)
2
3.76 m/s
2
3.15 m/s
230V~50 Hz
370 W
11,000 min
1.4 mm
250 mm
94 dB(A)
DK N FIN
English
Vibration
- Front Handle
- Rear Handle
DESCRIPTION
1. Main handle
2. Lock-off button
3. Trigger
4. Palm handle
5. Electric power cord
6. Live power indicator
7. Crutch handle (RLT3725CH-A only)
8. Height adjustment button
9. Lower shaft
10. Upper shaft
11. Steel wire guide
12. Rotating release
13. Motor housing
14. Foot pedal (RLT3725CH-A only)
15. Safety guard
16. Spool
17. Bump button
18. Nylon line
19. Bump head
20. Cut-off blade
ASSEMBLY
The line trimmer is supplied with some components
not assembled. To assemble these, proceed as follows:
SHAFT ASSEMBLY (Fig. 2)
By clutching the upper part of the line trimmer under
■
your right arm and with your left hand holding the
-1
lower shaft (9), carefully position the upper shaft (10)
over the lower shaft.
With your right thumb, push forward the height
■
adjustment button (8) then gradually lower the upper
shaft over the lower shaft. Turn/rotate the upper shaft
as necessary to ensure it goes onto the lower shaft in
the correct orientation.
As you insert the upper part over the lower part, take
■
care not to damage the cable and that the cable
resides comfortably without strain inside the shafts.
Note: There is a paper tag on the shaft to help
-1
explain this assembly. Remove this tag once the
assembly is complete.
12
GR TR EST
3.76 m/s
3.15 m/s
LT LV
2
2