4Th Level Programming - BFT PERSEO CBE FW 1.2.X Manuel D'installation Et D'utilisation

Programmable PDM input for spe-

cial functions
Radio channel 1 command selec-

tion

Select mains frequency

E iting the menu/saving
Description of level 3 para eters

· : Input polarity
For N.O. or N.C. input polarity confi guration.

· : Output 4 polarity, Output 5 polarity
Output polarity: The outputs can be confi gured as N.O. or N.C.. NOTE: in the event of a power failure the N.C. contact opens anyway.

· : Output polarity
The outputs can be confi gured as N.O. or N.C.. NOTE: in the event of a power failure the N.C. contact opens anyway.

· : Enable command during the pause time
Depending also upon other settings, the system accepts or not the commands from inputs.

· : Special PDM functions
= PDM is used as opening enable. As long as it is not active, no opening command is accepted. Also no close command is ac-
cepted so the bollard remains open.
= The PDM functions as described in point 1, but in case of automatic logic, the pause time is reloaded.
= The PDM function enables the TERMON system. Based on the setting of the  parameter, the closing or opening of the
contact activates or deactivates the TERMON system. This allow the TERMON function to be controlled by a calendar and/or
a thermostat.

· : Pressure switch polarity
N.O.: Pressure switch type used until 2012.
N.C.: Pressure switch type used from 2013 on.
The following table gives the 4th level functions and the adjustable parameters.
= DEFAULT value set in factory.
Par Function

Communication protocol

U-LINK mode

U-LINK adress

Modbus/RTU ID

MODBUS RTU speed

Cycles counter

Historical errors
38 - PERSEO CBE
: None
: Opening Enable when active
: Opening Enable and pause time reset (with =), when active
: TERMON Enabled when active
: Opening Enable and pause time reset (with =), when active
: Receiver channel 1 not used
: Receiver channel 1 mapped to START
: Receiver channel 1 mapped to OPEN (with = special function)
: Value of main frequency in Hertz (Hz)
Pressing the "F" key e its the programming menu and changes are saved
4TH
8.5 LEVEL PROGRAMMING
Settable data
: disabled
: U-LINK
: Modbus/RTU
: Slave
: Master

: For Slave
: For Master
.: 19 200 baud
. 38 400 baud
Read only parameter, in thousands ( 1000)
: do not clear (keeps) the list
: clear the list
= parameter value set during installation: should be fi lled if
DEFAULT value is modifi ed.







.

