Installation D Controlled Entry And Automatic Exit - BFT PERSEO CBE FW 1.2.X Manuel D'installation Et D'utilisation

13.4
This solution is recommended when you want to enter a reserved area in both directions. Entry is by means of a command while e iting is
automatic.
ENTRY
EXIT
Loops S1 and S2 also have a safety function in that they will not let the bollard to ove all the ti e if the vehicle is over S1 or S2.
RECOMMENDED
DIMENSIONS
- Connect the contact of loop S1 receiver to PDM input.
- Connect the N.O. contact of the S2 loop receiver to OPEN
input.
- The dimensional values given are appro imate.
*
We suggest installing the "RME 2" metal mass detector.
INSTALLATION D
CONTROLLED ENTRY AND AUTOMATIC EXIT
The vehicle approaches
the reserved area.
When the vehicle is over loop S1 the
bollard will go down only after a com-
mand (e .: remote control).
If the device is rising and the user
wants to lower it again, the vehicle
must be over loop S1 and the com-
mand must be repeated.
When the vehicle leaves loop S2 the
bollard will rise automatically after an
adjustable pause time.
The vehicle approaches the reserved
area, when it is over the loop S2, the
bollard goes down.
PARAMETER DATA DESCRIPTION
 
Functioning logic: Automatic
 
Special function
 
Radio channel 1: Open
 
Command during pause is OFF
 
Close standard
When the vehicle leaves
loop S1 the device will
rise automatically after
an adjustable pause time.
PERSEO CBE 45
-