Optional Rear Spacer Cover; Electrical Connection - U.s.a. Only - Whirlpool GY398LXP Mode D'emploi

Optional Rear Spacer Cover

(for Slide-in Ranges Only)
If you are installing a slide-in range into an existing freestanding
range opening, you may use the rear spacer cover to fill in the
opening at rear of range.
Remove the outside screws from the rear trim on range. Use
screws to attach rear spacer bar to range.
A
A. Rear spacer cover
B. Attach using 2 screws

Electrical Connection - U.S.A. Only

Power Supply Cord
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Disconnect power.
2. Remove the terminal block cover screws located on the back
of the range. Pull cover down and towards you to remove
cover from range.
A. Hold-down screws
B. Terminal block cover
10
B
A
B
Power Supply Cord
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be
connecting to:
4-wire receptacle A UL listed,
(NEMA type 14-50R) 250 volt
minimum,
40-amp, range
power supply
cord
4-wire direct A fused
disconnect or
circuit breaker
5"
box
(12.7 cm)
3-wire receptacle A UL listed,
(NEMA type 10-50R) 250 volt
minimum,
40-amp, range
power supply
cord
3-wire direct A fused
disconnect or
1"
(2.5 cm)
circuit breaker
box
3"
(7.6 cm)
Go to Section:
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
3-wire connection:
Power supply cord
3-wire connection:
Direct wire