Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
11. Continue installing your range using the following installation
instructions.
Install Rear Vent
If you have a slide-in range, the rear vent must be installed.
Remove the outside screws from the rear trim on range. Use
screws to attach rear vent to range.
Verify Anti-Tip Bracket Location
1. On models with a storage drawer, pull drawer open to first
stop position. Lift front of drawer to clear white wheels in
drawer guides. Remove drawer and set it aside on a covered
surface.
On models with a warming drawer, the rear leg cannot be
seen by removing the warming drawer. It will be necesary to
view the rear foot from outside the range.
2. Making sure the anti-tip bracket is installed:
■
Look for the anti-tip bracket securely attached to floor.
■
Slide range back so rear range foot is under anti-tip
bracket.
Level Range
1. Place rack in oven.
2. Place level on rack and check levelness of the range, first
side to side; then front to back.
3. If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
On Ranges Equipped with Storage Drawers:
Use a wrench and pliers to adjust leveling legs up or down until
the range is level. Push range back into position. Check that rear
leveling leg is engaged in the anti-tip bracket.
On Ranges Equipped with Warming Drawers:
Use pliers to adjust leveling legs up or down until the range is
level. Push range back into position. Check that rear leveling leg
is engaged in the anti-tip bracket.
NOTE: Range must be level for satisfactory baking performance.
Make Gas Connection
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Typical rigid pipe connection
A combination of pipe fittings must be used to connect the range
to the existing gas line. Your connections may be different,
according to the supply line type, size and location.
1. Apply pipe-joint compound made for use with LP gas to all
pipe thread connections.
9
Publicité
Table des Matières
