Service Schedule; Handover Confirmation; Service Confirmation - Stihl GHE 150 Manuel D'utilisation

18. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Feed chute not properly closed - safety
cut-off switch actuated (motorstop)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Close feed chute properly and tighten
screws ( 11.2)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.3)
– Reset locking device (
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades (
48
Fault:
Shredding material is not drawn in
Possible cause:
– GHE 260: Incorrect rotational direction
of blade disc
Remedy:
– GHE 260: Change rotational direction
of blade disc (

19. Service schedule

19.1 Handover confirmation

8.6)
11.4)

19.2 Service confirmation

Please hand this instruction manual
to your STIHL specialist dealer in
the case of maintenance operations.
He will confirm the service operations
performed in the pre-printed boxes.
11.7)
10.6)
23
Service performed on
Next service date
0478 201 9913 B - EN