Unpacking The Washer; Installation Requirements; Electrical Requirements - GE PTAN9150MWW Manuel De L'utilisateur

Masquer les pouces Voir aussi pour PTAN9150MWW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UNPACKING THE WASHER

WARNING:
carton and plastic bags after the washer is
unpacked. Make materials inaccessible to
children. Children might use them for play.
Cartons covered with rugs, bedspreads, or plastic
sheets can become airtight chambers causing
suffocation.
Make sure you have removed all of the packaging
material from the top and bottom of the washer.

INSTALLATION REQUIREMENTS

DRAINAGE
A vertical standpipe with an internal diameter of 1-1/2"
(3.8 cm) is required. The standpipe height above the
floor must be:
Minimum height: 30" (76 cm)
Maximum height: 96" (243,8 cm)
Insert the drain hose into the standpipe and secure it
with the cable tie located inside the accessories bag.
The standpipe must be open to the atmosphere (there
must be an air gap around the drain hose).
If you need to extend the lenght of the drain hose to reach
your standpipe, please contact your local parts store to
purchase the recommended drain hose extension for your
washer.
CLEARANCES
If you are installing your washer in a closet or alcove,
you must consider additional clearances relative to the
dimensions of your washer, and provide proper
ventilation openings in the closet doors.

ELECTRICAL REQUIREMENTS

Read these instructions completely and carefully.
CIRCUIT –
Individual, properly polarized and grounded
15-amp branch circuit fused with 15-amp time-delay
fuse or circuit breaker.
POWER SUPPLY –
2-wire, with ground, 120-volt, single-phase,
60-Hz, Alternating Current.
OUTLET RECEPTACLE –
receptacle to be located so the power supply cord is
accessible when the washer is in an installed position.
Recycle or destroy the
Properly grounded 3-prong
Cable tie
38" (96.5 cm)
Closet door
3" (7,6 cm)
4"
(10,2 cm)
Must be lowered or
equivalent and have at
least 120 in (774 cm )
open area.
www.geappliances.ca
Tub protector
(including hoses and parts)
Corner supports
Base support
30" (76 cm)
minimum
96" (243,8 cm)
maximum
3" (7,6 cm)
3" (7,6 cm)
0"
0"
(0 cm)
(0 cm)
5

Publicité

Table des Matières
loading

Table des Matières