GE PTAN9150MWW Manuel De L'utilisateur page 15

WATER
Washer takes too
long to fill or it
doesn't fill
OPERATION
Washer won't operate
Possible Causes
Washer is unplugged or
there is no power
Water supply is turned off
Hoses are kinked or
obstructed
The valve filters are
obstructed
Low water flow
Possible Causes
Washer is unplugged
Water supply is turned off
Controls are not set properly
Lid is open―safety feature
prevents agitation and
spinning when lid is up
Circuit breaker/fuse is
tripped/blown
Electronics need to be reset
START was not pressed
What To Do
• Make sure cord is plugged securely into a working outlet
and be sure there is power.
•
Make sure cord is plugged securely into a working outlet
and be sure there is power.
Turn both hot and cold faucets fully on.
•
•
Check the hoses and fix or replace them if necessary. Turn
the faucets off, disconnect the hoses and clean the filters.
•
Check if you have another open faucet and close it
What To Do
• Make sure cord is plugged securely into a working outlet.
• Turn both hot and cold faucets fully on.
• Check controls.
• Close lid and reset cycle, to the beginning if necessary.
• Check house circuit breakers/fuses. Replace fuses or
reset breaker. Washer should have a separate outlet.
• Unplug washer, wait 2 minutes, plug back in and press START.
• Press START.
•
•
•
•
•
•
•
•
•
www.geappliances.ca
15